MetalworkingFun Forum › Machining › How-To's v
a chuck refit

Thread Modes
a chuck refit
SnailPowered Offline
Junior
****
Posts: 258
Threads: 13
Joined: Aug 2012
Location: USA
#16
09-11-2012, 12:49 PM
What is D-2 tool steel then? Not trying to be a smart ass just wondering. I don't know a lot about metal grades but have seen lots of knives that were D2.
SnailPowered, proud to be a member of MetalworkingFun since Aug 2012.
Reply
Thanks given by:


Messages In This Thread
a chuck refit - by krv3000 - 09-08-2012, 04:54 PM
RE: a chuck refit - by EdK - 09-08-2012, 04:56 PM
RE: a chuck refit - by DaveH - 09-08-2012, 05:00 PM
RE: a chuck refit - by stevec - 09-08-2012, 05:19 PM
RE: a chuck refit - by krv3000 - 09-09-2012, 05:24 PM
RE: a chuck refit - by stevec - 09-09-2012, 05:45 PM
RE: a chuck refit - by sasquatch - 09-09-2012, 05:54 PM
RE: a chuck refit - by Micktoon - 09-10-2012, 02:47 PM
RE: a chuck refit - by doubleboost - 09-10-2012, 03:02 PM
RE: a chuck refit - by doubleboost - 09-11-2012, 04:12 PM
RE: a chuck refit - by krv3000 - 09-10-2012, 04:50 PM
RE: a chuck refit - by stevec - 09-10-2012, 06:30 PM
RE: a chuck refit - by EdK - 09-11-2012, 06:21 AM
RE: a chuck refit - by Mayhem - 09-11-2012, 06:53 AM
RE: a chuck refit - by EdK - 09-11-2012, 12:10 PM
RE: a chuck refit - by stevec - 09-11-2012, 07:42 AM
RE: a chuck refit - by SnailPowered - 09-11-2012, 12:49 PM
RE: a chuck refit - by dallen - 09-11-2012, 01:33 PM
RE: a chuck refit - by doubleboost - 09-11-2012, 02:30 PM
RE: a chuck refit - by DaveH - 09-11-2012, 04:05 PM
RE: a chuck refit - by EdK - 09-11-2012, 05:08 PM



Users browsing this thread: 3 Guest(s)