hi this was bin thrown out at work so i saved it its a burnerd chuck 3.1/2" od in all it was ok a part fron one folt the pics will explane a lot but the mane folt of the chuck was a broken tooth on jaw No2 ther is tow ways to reper this one is to mack a nwe tooth and silver solder it in or fit a pin i fited a pin i drilld a hole with a dimond bur then made a pin that was a tite fit and prest it in then cut it to lenth and it works ok right pics
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.