Tooling up a mill

[EdK]

(03-10-2012, 09:41 AM)arvidj Wrote: Ed,

Just as an FYI, my invoice lists ISO30 along with the power option on the last line. I am sure it will not affect the price but just in case you missed it in your specifications.

Arvid

Arvid,

I specified the standard configuration for this quote. That would have the ISO40 vertical and the ISO30 horizontal spindles. ISO40 tooling is much easier to find so considering I'd need more tooling for the vertical spindle I'm thinking I might go with an ISO40 vertical spindle. I can't see needing a whole lot of tooling for the horizontal spindle, but I could be wrong. I probably won't make that decision until I'm ready to pull the trigger. So the only option I had specified for this last quote was the 1000mm table.

Ed