MetalworkingFun Forum › Machining › General Metalworking Discussion v
Making a threading dial

Thread Modes
Making a threading dial
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#3
09-02-2012, 12:03 AM
That makes sense Greg - I cannot recall having seen it stop before though. Mind you, I haven't used it very often.

Either way, I'd still like to make a new face, so I don't have to wait for the one mark to come around.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Making a threading dial - by Mayhem - 09-01-2012, 10:44 PM
RE: Making a threading dial - by f350ca - 09-01-2012, 11:56 PM
RE: Making a threading dial - by Mayhem - 09-02-2012, 12:03 AM
RE: Making a threading dial - by TOM REED - 09-02-2012, 01:57 AM
RE: Making a threading dial - by Mayhem - 09-02-2012, 02:20 AM
RE: Making a threading dial - by Tony Wells - 09-02-2012, 02:40 AM
RE: Making a threading dial - by Mayhem - 09-02-2012, 02:48 AM
RE: Making a threading dial - by Hopefuldave - 09-02-2012, 05:35 AM
RE: Making a threading dial - by Highpower - 09-02-2012, 11:24 AM
RE: Making a threading dial - by big job - 09-02-2012, 05:12 AM
RE: Making a threading dial - by Mayhem - 09-02-2012, 06:10 AM
RE: Making a threading dial - by stevec - 09-02-2012, 07:16 AM
RE: Making a threading dial - by Mayhem - 09-02-2012, 08:48 AM
RE: Making a threading dial - by Hopefuldave - 09-02-2012, 12:44 PM
RE: Making a threading dial - by ScrapMetal - 09-02-2012, 02:55 PM
RE: Making a threading dial - by Mayhem - 09-04-2012, 08:16 AM
RE: Making a threading dial - by TOM REED - 09-04-2012, 08:47 AM
RE: Making a threading dial - by SnailPowered - 09-04-2012, 09:59 AM
RE: Making a threading dial - by dallen - 09-04-2012, 10:02 AM
RE: Making a threading dial - by stevec - 09-05-2012, 07:11 AM
RE: Making a threading dial - by Mayhem - 09-05-2012, 07:22 AM
RE: Making a threading dial - by stevec - 09-05-2012, 06:26 PM



Users browsing this thread: 4 Guest(s)