How to Make Custom Length Bandsaw Blades Without Welding
#41
Tom, I don't know what % the solder I used was. It was a piece I found in my Dad's torch box. It could well be 50% or higher. Unfortunately, Dad is not here to ask. I do have a roll of known 45% that I bought. Next time I run into 50% or higher, I'll pick up some.
I will have to put one of the soldered blades on the saw and try it.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)