Storebro 15 x 36 Lathe (I think)
#71
(02-06-2021, 11:42 PM)Hawkeye Wrote:
(02-06-2021, 08:55 AM)RAFALW Wrote: Witaj WillBob , jaki masz wybity numer tokarki na końcu łoża? Piszesz że twoja tokarka jest z lat 1940 , i mnie jest nr 2600 , mógłbym sobie porównać..... pozdrawiam

Hello WillBob, what's your lathe number stamped on the end of the bed? You write that your lathe is from 1940, and I am No. 2600, I could compare myself ..... Regards


Mine carries S.N. 2774, which Storebro Bruk told me was built in 1943.

Teraz wiem że moja jest z początku lat 40-tych albo i starsza....przedwojenna.......ale i tak jest to fajny sprzęt...... dziękuję i pozdrawiam
Reply
Thanks given by:
#72
Mógłbyś mi napisać do czego służy to urządzenie zaznaczone na zdjęciu?? . U mnie nie ma tego


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#73
Mógłbyś mi napisać do czego służy to urządzenie zaznaczone na zdjęciu?? . U mnie nie ma tego

Could you please tell me what the device marked in the picture is for? . I don't have it


It isn't on mine either. Could it be some kind of carriage stop or thread gauge (although I don't see any connection to the leadscrew.)?
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
#74
It looks to me to be an older form of a "Trav-a-dial" that measures the distance the carriage travels using a rubber contact wheel against the front of the bed.

https://www.maskinisten.net/viewtopic.ph...2&start=15
Willie
Reply
Thanks given by:
#75
Mine has serial number 2952, Storebro said it was from 1944. You can contact Storebro to get more information.

http://storebro.eu/en/contact
Reply
Thanks given by:




Users browsing this thread: