MetalworkingFun Forum › Machinery › Lathes v
Mini-Lathe Bearing Puller

Thread Modes
Mini-Lathe Bearing Puller
EdK Offline
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#51
06-16-2023, 04:34 PM
(06-16-2023, 04:01 PM)rleete Wrote: Mine came with that.  Doesn't seal all that well, but it keeps the vast majority out.

Yup, it's certainly much better than without it. Thumbsup

Ed
Reply
Thanks given by:
EdK Offline
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 5 users Like EdK's post:
Vinny (07-06-2023), Highpower (07-06-2023), f350ca (07-06-2023), JScott (07-07-2023), arvidj (07-09-2023)
#52
07-06-2023, 05:28 PM
Finally got the aluminum spacer done to replace the plastic spacer with. Haven't spent a lot of time in the shop lately.
It took a while to bore that out. Either I'm getting used to the gear noise or it has settled down some. After running the lathe non stop for a couple of hours the head-stock where the bearings are located was slightly warm, not even lukewarm though. I think the preload is good for now. Of course I have to undo that to install the spacer. Bash

Ed

   
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)