MetalworkingFun Forum › Machining › General Metalworking Discussion v
Mini lathe surprise

Thread Modes
Mini lathe surprise
nitram55 Offline
Freshman
**
Posts: 1
Threads: 1
Joined: Apr 2020
Location: england
#1
10-15-2021, 01:54 PM
Striping my Mini Lathe down to replace the drive belt, decided to take the headstock off to check the internal gears while I was at it, this is what I found.

If at first you don't succeed just drill it again.


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
Highpower Offline
JAFO
******
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#2
10-15-2021, 06:10 PM
All the more reason to tear them down right out of the box and give everything a good cleaning and inspection.
Willie
Reply
Thanks given by:
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#3
10-15-2021, 06:33 PM
WOW! They could at least plugged the incorrect holes.
Reply
Thanks given by:
EdK Offline
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#4
10-16-2021, 10:03 AM
Yikes! Yikes

Ed
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)