07-03-2012, 05:00 PM
Fixing a Leaky RF-45 Mill Head - Enco
|
07-03-2012, 05:03 PM
Ed,
I can see it now - Thanks DaveH
07-03-2012, 05:50 PM
07-03-2012, 05:55 PM
Ed,
That is good news Seems you did a good job DaveH
07-03-2012, 05:57 PM
Dave,
Not so quick. Tomorrow morning with tell whether I did a good job, but thanks anyway. Ed
07-03-2012, 06:52 PM
Looking good so far Ed. Well done. It is always nice to be able to put something back together and not have bits left over. You don't have bits left over do you?
Just kidding!
Hunting American dentists since 2015.
07-03-2012, 07:13 PM
(07-03-2012, 06:52 PM)Mayhem Wrote: Looking good so far Ed. Well done. It is always nice to be able to put something back together and not have bits left over. You don't have bits left over do you? Not yet, but then I haven't reassembled the spindle and downfeed mechanism yet so there's still hope, or is that tragedy. Ed
07-03-2012, 11:37 PM
(07-03-2012, 05:50 PM)EdK Wrote: It appears we have primary fluid retention. When did this turn into a shuttle launch?
Willie
(07-03-2012, 11:37 PM)Highpower Wrote:(07-03-2012, 05:50 PM)EdK Wrote: It appears we have primary fluid retention. Shuttle launch? I thought he was commenting on his ailing health. I was going to suggest diuretics but this would be unwise without a full medical history, blood work up etc!
Hunting American dentists since 2015.
07-04-2012, 06:45 AM
well dun
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)