Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
I doubt the ubiquitous Chinese ones we all use are anything more than 1018...
Hunting American dentists since 2015.
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
EdK (10-24-2017)
I like to harden any tools I make. It makes them much more durable, especially in the case of tee-nuts, which take quite a beating in use. Just be sure to temper them after hardening so they aren't brittle.
Tom
Posts: 10
Threads: 0
Joined: Oct 2017
Location: mays landing NJ
The following 1 user Likes kwoodhands's post:
schor (11-03-2017)
(09-18-2017, 04:22 AM)Pete O Wrote: I'm making some T-nuts out of a chunk of forklift tyne- presumed 4140- wondering whether I should heat-treat them when done or if I'm best leaving the material as-is to avoid making the threads brittle? They'll be threaded 1/2-13 UNC to match some existing hardware and set aside for use on the shaper.
I wouldn't bother to heat treat unless you will give them heavy use. I have made T-Nuts from CRS, even aluminum for light duty work holding. I use an aluminum T-Nut to hold a indicator on the mill. I threaded one end of a 3/8 shaft to fit the T-Nut. The indicator bracket slides over it and locks at any height.
If you make T-Nuts, make sure you deform the thread at the bottom , prevents the studs from chewing up the mill slot. Store bought T-Nuts are made that way. I do this with a hammer and cape chisel.
mike
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
(11-03-2017, 04:54 PM)kwoodhands Wrote: I wouldn't bother to heat treat unless you will give them heavy use. I have made T-Nuts from CRS, even aluminum for light duty work holding. I use an aluminum T-Nut to hold a indicator on the mill. I threaded one end of a 3/8 shaft to fit the T-Nut. The indicator bracket slides over it and locks at any height.
If you make T-Nuts, make sure you deform the thread at the bottom , prevents the studs from chewing up the mill slot. Store bought T-Nuts are made that way. I do this with a hammer and cape chisel.
mike
Good tips Mike.
Oh, and
to the forum.
Ed