+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: T-nuts; heat treat or not? (/thread-3712.html)
T-nuts; heat treat or not? - Pete O - 09-18-2017
I'm making some T-nuts out of a chunk of forklift tyne- presumed 4140- wondering whether I should heat-treat them when done or if I'm best leaving the material as-is to avoid making the threads brittle? They'll be threaded 1/2-13 UNC to match some existing hardware and set aside for use on the shaper.
RE: T-nuts; heat treat or not? - SteveG - 09-18-2017
If you haven't annealed the material before starting I'd leave it as it is - its probably already a nice balance of hardness/toughness.
Steve
RE: T-nuts; heat treat or not? - Vinny - 09-18-2017
I made a number of T nuts and just used 1018.
RE: T-nuts; heat treat or not? - Mayhem - 10-24-2017
I doubt the ubiquitous Chinese ones we all use are anything more than 1018...
RE: T-nuts; heat treat or not? - TomG - 10-24-2017
I like to harden any tools I make. It makes them much more durable, especially in the case of tee-nuts, which take quite a beating in use. Just be sure to temper them after hardening so they aren't brittle.
Tom
RE: T-nuts; heat treat or not? - kwoodhands - 11-03-2017
(09-18-2017, 04:22 AM)Pete O Wrote: I'm making some T-nuts out of a chunk of forklift tyne- presumed 4140- wondering whether I should heat-treat them when done or if I'm best leaving the material as-is to avoid making the threads brittle? They'll be threaded 1/2-13 UNC to match some existing hardware and set aside for use on the shaper.
I wouldn't bother to heat treat unless you will give them heavy use. I have made T-Nuts from CRS, even aluminum for light duty work holding. I use an aluminum T-Nut to hold a indicator on the mill. I threaded one end of a 3/8 shaft to fit the T-Nut. The indicator bracket slides over it and locks at any height.
If you make T-Nuts, make sure you deform the thread at the bottom , prevents the studs from chewing up the mill slot. Store bought T-Nuts are made that way. I do this with a hammer and cape chisel.
mike
RE: T-nuts; heat treat or not? - EdK - 11-03-2017
(11-03-2017, 04:54 PM)kwoodhands Wrote: I wouldn't bother to heat treat unless you will give them heavy use. I have made T-Nuts from CRS, even aluminum for light duty work holding. I use an aluminum T-Nut to hold a indicator on the mill. I threaded one end of a 3/8 shaft to fit the T-Nut. The indicator bracket slides over it and locks at any height.
If you make T-Nuts, make sure you deform the thread at the bottom , prevents the studs from chewing up the mill slot. Store bought T-Nuts are made that way. I do this with a hammer and cape chisel.
mike
Good tips Mike.
Oh, and
to the forum.Ed