Todays Project - What did you do today?
here what I had to do with some of my clamps to get them out of the way


Attached Files Thumbnail(s)
   
jack
Reply
Thanks given by:
What did I do today? Stayed up too late, drank a bit too much, eat a bit to much, and danced rather a lot too much! Still only 364 days until next New Years Eve party :)
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
Yup, same here. I'm getting way too old to stay up till 4:00 AM. Slaphead

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
I actually made it to about 1:30AM. I haven't even made it to midnight on New Years in many years. It helped that there was a Dave Clark 5 special on PBS that lasted until 11:00PM.

Ed
Reply
Thanks given by:
(01-01-2015, 12:06 PM)EdK Wrote: I actually made it to about 1:30AM. I haven't even made it to midnight on New Years in many years. It helped that there was a Dave Clark 5 special on PBS that lasted until 11:00PM.

Ed

Mmm ... I bet that left you in bits and pieces Big Grin 
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
(01-01-2015, 12:13 PM)DaveH Wrote:
(01-01-2015, 12:06 PM)EdK Wrote: I actually made it to about 1:30AM. I haven't even made it to midnight on New Years in many years. It helped that there was a Dave Clark 5 special on PBS that lasted until 11:00PM.

Ed

Mmm ... I bet that left you in bits and pieces Big Grin 
Smiley-eatdrink004
DaveH

Rotfl Good one Dave. 5176

Ed
Reply
Thanks given by:
Lol. You should be glad all over that you didn't stay up until four.
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Rotfl  Rotfl  Rotfl
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
(01-01-2015, 12:34 PM)TomG Wrote: Lol. You should be glad all over that you didn't stay up until four.

Rotfl What have I started? Slaphead
Reply
Thanks given by:
It's just "Good Rock 'n' Roll"  Ooops Big Grin 
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:




Users browsing this thread: 22 Guest(s)