Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
(11-27-2014, 08:17 AM)EdK Wrote: Steve,
It's set up in the mill not the lathe. My boring head takes 1/2" shank tools and I haven't seen any of the carbide tipped Chinese boring tools with 1/2" shanks that will bore that deep.
Ed
Sorry Ed
. Thanks for straightening me out. Ya, the 9" bar that fits your boring head for the mill could provide 2 shorter ones, one with the tool at 90 deg. and the other at 45.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
Thanks for the suggestions guys. I went ahead and cut my boring bar to 5.5" before I left for my nephews for Thanksgiving dinner. It's only a $14.50 boring bar so certainly not the end of the world. Next I need to grind the 3/16" tool bit for it and then I'll be ready to bore out the hole. I had no wine at dinner so I'm clear to work with power tools this evening.
Ed
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 2 users Like EdK's post:
Mayhem (12-04-2014), Highpower (12-04-2014)
I just need to bore the 1" hole for the hold-down shaft and drill the 1/2" hole for the cotter clamp and the body will be done.
Ed
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
Looking good Ed, but that mill looks surgically clean
Free advice is worth exactly what you payed for it.
Greg
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
(12-04-2014, 05:30 PM)f350ca Wrote: Looking good Ed, but that mill looks surgically clean
Not even close Greg. See all of those chips in the table slots and on the rear way guard? I had just vacuumed off the chips from the drilling operation in preparation for boring the hole to 1"
Ed
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
The following 1 user Likes f350ca's post:
EdK (12-05-2014)
Aw
I think of the mess on mine as a protective layer material.
Free advice is worth exactly what you payed for it.
Greg
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 4 users Like EdK's post:
f350ca (12-07-2014), arvidj (12-07-2014), Mayhem (12-07-2014), PixMan (12-07-2014)
The body is finally done. On to the cotter clamp.
Ed
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
Ed that new camera must be the exceptionally shinny kind. Well done,
Free advice is worth exactly what you payed for it.
Greg
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
I think you're right. I haven't even given the body a proper cleaning yet and it already looks shinny.
Ed
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 2 users Like EdK's post:
PixMan (12-09-2014), Mayhem (12-09-2014)
I gave it a hat this evening.
Ed
