+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Setting Up KOC100 VFD (/thread-3017.html)
RE: Setting Up KOC100 VFD - 2w1USAF - 03-01-2016
(01-10-2016, 12:39 AM)Hawkeye Wrote: I haven't even looked at it all this week. Too frustrating. I just printed out the last three posts. I'll check all this out tomorrow. Thanks for the feedback. It especially helps to know that someone else has used one of these VFDs. And won!
Were you able to get your VFD up and running? I bought the same unit to use with my CNC router machine, but I cannot get it to run my 0.8kw spindle. I kind of messed up not getting a different VFD that has 400hz output, but this should still run the spindle at 300hz, right?
Any ideas/suggestions would be greatly appreciated!
Spindle specs:
0.8kw
6.5A
220V (3-phase)
400hz
RE: Setting Up KOC100 VFD - Hawkeye - 03-02-2016
I never did get it running properly. I gave up and used my old Teco FM50. So easy to use. Totally reliable.