+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Cross slide Brg mod & new dial. (/thread-732.html)
RE: Cross slide Brg mod & new dial. - TOM REED - 08-20-2012
Better than one you could buy excellent job tom
RE: Cross slide Brg mod & new dial. - doubleboost - 08-20-2012
Claude
Very nicely done & well documented
Thanks for showing us how it was done
John
RE: Cross slide Brg mod & new dial. - f350ca - 08-20-2012
Once again nice job Claude. Will give the numbers another try but the skim cut I've needed was deep enough to remove the offending mess.
Thanks
RE: Cross slide Brg mod & new dial. - ETC57 - 08-20-2012
Very nice Claude,
the dial looks like has always been there!
Thank you for the thread.
Jerry.
RE: Cross slide Brg mod & new dial. - SnailPowered - 08-21-2012
That dial definitely looks like it was manufactured at a very high quality shop!! Great job!!
RE: Cross slide Brg mod & new dial. - Mayhem - 08-21-2012
Very nicely done. The number spacing is spot on and from all attempts that is not the easiest thing to do.
RE: Cross slide Brg mod & new dial. - claudef - 08-21-2012
(08-20-2012, 07:58 PM)f350ca Wrote: Once again nice job Claude. Will give the numbers another try but the skim cut I've needed was deep enough to remove the offending mess.
Thanks
This is the setup I used for stamping the numbers... hope this helps.
Claude
RE: Cross slide Brg mod & new dial. - stevec - 08-21-2012
Hmmm, Still not giving away your secrets eh Claude.
RE: Cross slide Brg mod & new dial. - EdK - 08-21-2012
(08-21-2012, 01:40 PM)claudef Wrote: This is the setup I used for stamping the numbers... hope this helps.
Claude
I'm seeing nutn so nope, no help.
Ed
RE: Cross slide Brg mod & new dial. - claudef - 08-24-2012
(08-21-2012, 03:33 PM)EdK Wrote:(08-21-2012, 01:40 PM)claudef Wrote: This is the setup I used for stamping the numbers... hope this helps.
Claude
I'm seeing nutn so nope, no help.
Ed
Sorry guys, forgot to attach picture