MetalworkingFun Forum › Machining › Projects v
Holt Engine (maybe)

Thread Modes
Holt Engine (maybe)
Highpower Offline
JAFO
******
Posts: 4,452
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
The following 1 user Likes Highpower's post:
f350ca (02-13-2021)
#11
02-13-2021, 02:03 AM
Looks like that thing is going to be a brute!
Willie
Reply
Thanks given by:
haroldmulder Offline
Freshman
**
Posts: 32
Threads: 2
Joined: Jan 2014
Location: Niagara-on-the-lake, Ontario Canada
#12
02-13-2021, 08:28 AM
Very nice. Technically I can figure out where the seam should be based on the screw heads but visually lot harder to see. 
Very good work.

Harold
Reply
Thanks given by:
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#13
02-13-2021, 09:36 AM
Thanks Harold,
I added two 1/8 dowel pins to locate the halves, The sides were machined after assembly, but the ends mated up after machining each piece.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Highpower Offline
JAFO
******
Posts: 4,452
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#14
02-13-2021, 11:33 AM
(02-13-2021, 08:28 AM)haroldmulder Wrote: Very nice. Technically I can figure out where the seam should be based on the screw heads but visually lot harder to see. 
Very good work.

Harold

I agree. At first glance it all appeared to be a single block (no pun intended) of aluminum until I noticed the screw heads. That is quite a fit!
Willie
Reply
Thanks given by: f350ca




Users browsing this thread: 3 Guest(s)