03-05-2016, 09:40 AM
That thread looks fine in more ways than one. 
What did you use?
Have you tried it yet?
John
What did you use? Have you tried it yet?
John
|
Home Shop Made Tools
|
 Thanks given by: Mayhem
03-05-2016, 10:19 AM
Thanks John - The thread was cut using a "laydown" threading insert. It is a 1.0 metric pitch.
I used it today to cut a collet a friend had made for a .50 bullet puller he is building. The collet grabs the case around the extraction groove.
Hunting American dentists since 2015.
03-05-2016, 10:47 AM
Between centers - good man. I use a pointy stick in the chuck, marked for #0 so it goes in the same way each time. The dog leans up against one of the jaws. Much easier/quicker than mounting a faceplate and a much better choice than using the chuck as a chuck on one end.
I present my shiny new threading bar. And the lack of adjustable dials on the mill/drill bit me again on the setscrews.. "was that two turns plus 78, or..?" No matter, it's a rock solid 3/4" bar. Even at a 5" stickout there wasn't a hint of chatter. The last image is the finished thread. This was done on a horizontal mill using the .050" feed (for 20 TPI) and plunging .005" straight in for each pass. The last two passes were spring cuts. 
03-05-2016, 12:26 PM
I like it, home made tool threads are always the best!
Magazines have issues, everything else has problems
03-05-2016, 01:31 PM
(03-05-2016, 10:47 AM)Sunset Machine Wrote: Between centers - good man. I use a pointy stick in the chuck, marked for #0 so it goes in the same way each time. The dog leans up against one of the jaws. Much easier/quicker than mounting a faceplate and a much better choice than using the chuck as a chuck on one end. One should still take a clean-up cut on the center before turning in between centers. I'm sure your method is close, but there are times when close is not good enough. 
03-05-2016, 01:54 PM
Technically, of course. But I've put a dial on it, dead steady. That's why it's marked for 0. If I were concerned, I'd do exactly what you suggest before I'd bother with a faceplate and hard center. That gets OLD quick.
03-05-2016, 03:06 PM
Darren , nicely done mate  Rob Thanks given by: Mayhem
03-05-2016, 04:52 PM
Yep, nicely done Darren
 DaveH
a child of the 60's and 50's and a bit of the 40's
Thanks given by: Mayhem
03-05-2016, 07:29 PM
I used the same setup as you Sunshine.
Hunting American dentists since 2015.
03-06-2016, 12:16 PM
Sunshine. <chuckle> That's what we call smart-asses. I might have deserved that, but you did say "the first time". Many put a center pop in and bring it out to the tailstock, still using the chuck and forcing the work into place. It seems innocent enough, sometimes unavoidable, but.
Mind a little remark? Your external thread looks rough. I can't tell from the pic if the tool rubbed, dull, or if the threads just need to be dusted. A wire brush and emery looked like they might help. Or maybe I should find my glasses. |
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 6 Guest(s)