MetalworkingFun Forum › Machining › General Metalworking Discussion v
My dumpster diving results

Thread Modes
My dumpster diving results
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#1
03-21-2015, 11:11 PM

.pdf   dumpster diving.pdf (Size: 1 MB / Downloads: 23)

From steel shipping crates for ZTR mowers

1 1/2" SQ X 1/16

12@31.5

3/4 SQ X 1/16

4@62"
8@52/53 inches
6@29.5"

1 1/2 X 1 1/2 X 3/16 angle

6@54"
6@36"
1@33"

1 X 2 X 1/16 wall rectangular tubing

6@73.5"
10@65"
8@56.5"

1" SQ X 1/16 wall

2@74"
4@66.5"
2@62"
4@53"
2@48"
4@44"
8@14/15 inches
8@17"
2@20"

Not bad IMHO.  Happyyes
Reply
Thanks given by:
Hopefuldave Offline
Sophmore
***
Posts: 168
Threads: 6
Joined: Mar 2012
Location: Surrey, England
#2
03-22-2015, 03:36 AM
Nice haul, Stan - I'd haggle a trade if you were the right side of the pond ;0)

Any plans for it all, or was it just tooo good to let go to waste?
Rules are for the obedience of fools, and the guidance of wise men...
(Douglas Bader)
Reply
Thanks given by:
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#3
03-22-2015, 03:41 AM
You Suck
Hunting American dentists since 2015.
Reply
Thanks given by:
EdK Offline
Whipping Boy
*******
Posts: 8,889
Threads: 320
Joined: Feb 2012
Location: Arizona/Minnesota
#4
03-22-2015, 09:25 AM
Yup, that's a good haul deserving of a You Suck

Ed
Reply
Thanks given by:
mike-sid Offline
Sophmore
***
Posts: 137
Threads: 16
Joined: Jan 2015
Location: Oxford, CT
#5
03-22-2015, 08:16 PM
you can make a nice material rack like Ken got , with plenty left over to put on it! You Suck
Reply
Thanks given by:
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#6
03-23-2015, 10:45 AM
(03-22-2015, 03:41 AM)Mayhem Wrote: You Suck

Thanks.  No plans for the material as of this writing, but I certainly could not let all of the steel go into the dumpster.  Metal storage racks is certainly one possibility.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)