+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: My dumpster diving results (/thread-2595.html)
My dumpster diving results - Dr Stan - 03-21-2015
[attachment=10375]
From steel shipping crates for ZTR mowers
1 1/2" SQ X 1/16
12@31.5
3/4 SQ X 1/16
4@62"
8@52/53 inches
6@29.5"
1 1/2 X 1 1/2 X 3/16 angle
6@54"
6@36"
1@33"
1 X 2 X 1/16 wall rectangular tubing
6@73.5"
10@65"
8@56.5"
1" SQ X 1/16 wall
2@74"
4@66.5"
2@62"
4@53"
2@48"
4@44"
8@14/15 inches
8@17"
2@20"
Not bad IMHO.
RE: My dumpster diving results - Hopefuldave - 03-22-2015
Nice haul, Stan - I'd haggle a trade if you were the right side of the pond ;0)
Any plans for it all, or was it just tooo good to let go to waste?
RE: My dumpster diving results - Mayhem - 03-22-2015
RE: My dumpster diving results - EdK - 03-22-2015
Yup, that's a good haul deserving of a
Ed
RE: My dumpster diving results - mike-sid - 03-22-2015
you can make a nice material rack like Ken got , with plenty left over to put on it!
RE: My dumpster diving results - Dr Stan - 03-23-2015
(03-22-2015, 03:41 AM)Mayhem Wrote:
Thanks. No plans for the material as of this writing, but I certainly could not let all of the steel go into the dumpster. Metal storage racks is certainly one possibility.