|
Drawbar Wrench/Hammer
|
06-09-2013, 04:56 PM
Since the secret project is no longer secret I thought I'd start a thread on it.
An exploded assembly and a couple of pictures so far. Ed
06-09-2013, 05:01 PM
Looking good Ed
I used copper on mine as brass tends to "spit" bits out Not a good idea at eye level John Thanks given by: EdK
06-09-2013, 05:12 PM
06-09-2013, 05:15 PM
06-09-2013, 05:30 PM
(06-09-2013, 05:15 PM)doubleboost Wrote:(06-09-2013, 05:12 PM)EdK Wrote:(06-09-2013, 05:01 PM)doubleboost Wrote: Looking good Ed I dunno I've had my Brass hammer for about 100yrs. and no problems. I can still see pretty good out of one eye. 
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
06-10-2013, 07:04 AM
Well, there's really no clear lines between brass/copper/zinc alloys. There's a million of them.
I don't think I'll be able to use one of those. The Alliant mill has a long hex draw bar. While that allows you to change tools without fully retracting the quill, it means less clearance on top when you DO retract it. 
06-10-2013, 07:16 AM
(06-09-2013, 04:56 PM)EdK Wrote: Since the secret project is no longer secret I thought I'd start a thread on it... You should take that as a compliment Ed - you machining of one part was so good that I was able to figure out your top secret plan.
Hunting American dentists since 2015.
Thanks given by: EdK
06-10-2013, 10:09 AM
(06-10-2013, 07:16 AM)Mayhem Wrote:(06-09-2013, 04:56 PM)EdK Wrote: Since the secret project is no longer secret I thought I'd start a thread on it... Boy! I thought I could suck up. 
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
