04-21-2013, 08:39 AM
Intake opened up and carb mounted. Binder works fine. Just have to shape it now. 1 hour tops.
"Billy G"
"Billy G"
|
P&W 1830 Radial in 1/6 scale.
|
04-21-2013, 12:40 PM
That's very nice Billy,
 Hope your wife is well on the mend  DaveH 
04-22-2013, 05:19 AM
Well done Billy!
Ed 
04-23-2013, 04:09 PM
The casting needs finish work now, first the lathe , then mill, and back to the lathe. For ease of finding the center in each machine this tool was fabricated. It will also keep everything flat.
"Billy G" 
04-23-2013, 05:15 PM
hi and my i say brilliant work
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
04-23-2013, 05:31 PM
(04-23-2013, 04:09 PM)Bill Gruby Wrote: The casting needs finish work now, first the lathe , then mill, and back to the lathe. For ease of finding the center in each machine this tool was fabricated. It will also keep everything flat. I'm not sure what I'm looking at Billy but it looks impressive none the less.  Ed
04-23-2013, 05:36 PM
(04-23-2013, 05:31 PM)EdK Wrote:(04-23-2013, 04:09 PM)Bill Gruby Wrote: The casting needs finish work now, first the lathe , then mill, and back to the lathe. For ease of finding the center in each machine this tool was fabricated. It will also keep everything flat. Ed; The heavy aluminum piece in the chuck is the fixture. It is made with that much mass to absorb vibration while cutting the thin casting. The casting is on a spigot and bolted in the center. This fixture will allow me to bore the offset holes for both distributors. and any other mill work. Then back into the lathe for final cuts. "Billy G" |
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 20 Guest(s)