P&W 1830 Radial in 1/6 scale.
#1 very close to finished. Some relieving and shaping yet. I will get #2 to this point and finish them both at the same time. That is a blank that #1 is resting on. Much waste.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
And then there were two almost done. LOL

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
Really nicely done Billy Thumbsup Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Bookmatched, they are a done deal.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
(05-09-2013, 05:00 PM)Bill Gruby Wrote: Bookmatched, they are a done deal.

"Billy G"

Very nice Bill
Small parts scare me
John
Reply
Thanks given by:
The "pucker factor" went up considerably while doing these John.

"Billy G" Big Grin
Reply
Thanks given by:
Excellent craftsmanship Billy. Those are really small parts. Thumbsup

Ed
Reply
Thanks given by:
Delrin arrived Friday . I have one Distributor cap blank - ready to mill. I will get the other to this point then mill them both.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
That's two. Into the mill tomorrow then back into the lathe to finish up.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
10 -- .125 X .406 holes done. This one goes back to the lathe. One more to go.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:




Users browsing this thread: 6 Guest(s)