Todays Project - What did you do today?
Billy,
Quite a nifty holding device Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Cool tool Bill. Smile

A watchmaker with arthritis? That is just plain wrong. Sadno

But then again I am biased because of not being able to do overhead work due to similar issues with bum shoulders.

Dear Mr. Old Age,

You Suck

Big Grin Big Grin Big Grin
Willie
Reply
Thanks given by:
All done except for cosmetics.

"Billy G" Thumbsup


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
Picked up a "Do-All" commercial belt sander from probably the 60's or 70's.

Runs pretty good, and all there, (Electrics are old, being changed,) But quite a mess, must have been in a body shop or someplace as it is covered in many coats of overspray, and lots of paint spilt on it.
Have it dismantled and partly stripped. Trying to locate a local supplier of the belts which are 3in x 48 inch.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:
No pictures, it didn't happen.
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
I cleaned up the little vise with a "Flycutter". Now it's presentably. Rotfl


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
(02-06-2013, 06:17 PM)Bill Gruby Wrote: I cleaned up the little vise with a "Flycutter". Now it's presentably. Rotfl

That's a beauty William!

Ed
Reply
Thanks given by:
Thank you Ed. Someone asked me once what my definition of a "Flycutter" was. I told him it was a Facing Tool for a Milling Machine.

"Billy G" Thumbsup
Reply
Thanks given by:
Bill looks great!! Smiley-signs107
how exactly dose it work?
It appears that it would actually pull on a part secured between the posts as you tighten the wing nut rather than clamp. 17428
JerryPopcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
(02-06-2013, 09:27 PM)ETC57 Wrote: Bill looks great!! Smiley-signs107
how exactly dose it work?
It appears that it would actually pull on a part secured between the posts as you tighten the wing nut rather than clamp. 17428
JerryPopcorn

Jump back one page Jerry and check out posts 787 and 790.
Hunting American dentists since 2015.
Reply
Thanks given by: ETC57




Users browsing this thread: 18 Guest(s)