Todays Project - What did you do today?
Hi Lads  Big Grin


I made a start on stripping down the CUB lathe  Cool motor and switch gear salvaged .


[Image: P1100786_zpsys6mblom.jpg]
[Image: P1100787_zps0rofobny.jpg]
[Image: P1100789_zps7dpurdqg.jpg]


I will pull the lead screws ,TTA and a few other parts from it tomorrow night . 

Cheers Rob
Reply
Thanks given by:
(01-06-2016, 04:46 PM)RobWilson. Wrote: [Image: P1100787_zps0rofobny.jpg]

Cheers Rob

Nice convenient ring atop that motor. Lift that out with your pinky finger did you Rob? Big Grin
Willie
Reply
Thanks given by:
(01-06-2016, 05:12 PM)Highpower Wrote:
(01-06-2016, 04:46 PM)RobWilson. Wrote: [Image: P1100787_zps0rofobny.jpg]

Cheers Rob

Nice convenient ring atop that motor. Lift that out with your pinky finger did you Rob?  Big Grin

Hi Willie 

Nope I had to knock it up three notches to my  flip the bird finger  Big Grin


Rob
Reply
Thanks given by:
Got them installed. Cut the floor back about 26 inches at the top and had to sink the one stringer into the lath and plaster wall to get the width I wanted.
The hole.
[Image: G0020090.jpg]

Installed
[Image: G0060095.jpg]

[Image: IMG_2008.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Looks good Greg!!
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by: f350ca
Thanks, we'll soon be returning to the original metal working broadcast.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Very good Thumbsup 
Smiley-eatdrink004 
DaveH
 a child of the 60's and 50's and a bit of the 40's Smile
Reply
Thanks given by:
The old lathe is getting smaller  Big Grin


[Image: P1100799_zpsjtbzx3pp.jpg]


Ready for cutting up with the plasma cutter at the weekend  Cool


Rob
Reply
Thanks given by:
What was wrong with the Cub that you had to scrap the poor thing Rob ?
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
(01-07-2016, 04:01 PM)awemawson Wrote: What was wrong with the Cub that you had to scrap the poor thing Rob ?

http://www.metalworkingfun.com/thread-2878.html


A few things Andrew ,but mainly I need the room for a larger lathe and I dont have the time to mess with it ,plus  I want the twin speed motor out of it for my Aceria mill . 


Rob
Reply
Thanks given by:




Users browsing this thread: 122 Guest(s)