Todays Project - What did you do today?
Top is 1/2" thick. Edges and slots are all square which helps when laying parts out.
Hunting American dentists since 2015.
Reply
Thanks given by:
(11-23-2015, 05:25 PM)Mayhem Wrote: Top is 1/2" thick. Edges and slots are all square which helps when laying parts out.

Nice! That's 1/2" thicker then mine. Thumbsup

Ed
Reply
Thanks given by: Mayhem
They came out very nice Mike Thumbsup 
Nice clean shop Smile 
Smiley-eatdrink004 
DaveH
 a child of the 60's and 50's and a bit of the 40's Smile
Reply
Thanks given by: zmotorsports
(11-23-2015, 12:39 PM)zmotorsports Wrote: It is nothing but an outdate phone book that I cut into a couple of 1.5" strips keeing the binding intact.

Mike, what did you use to slice up the phone book so cleanly? Chin
Willie
Reply
Thanks given by:
Dunno what Mike used, but clamping a book between two pieces of wood will allow you to cleanly cut it with a band saw.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
I just grab them and rip them in half Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:
(11-23-2015, 05:08 PM)Pete O Wrote: Nice job Mike. I like the phone-book edge finder thing too, very time-efficient.

(11-23-2015, 05:58 PM)DaveH Wrote: They came out very nice Mike Thumbsup 
Nice clean shop Smile 
Smiley-eatdrink004 
DaveH

Thanks guys.  I appreciate the comments.


(11-23-2015, 09:41 PM)Highpower Wrote:
(11-23-2015, 12:39 PM)zmotorsports Wrote: It is nothing but an outdate phone book that I cut into a couple of 1.5" strips keeing the binding intact.

Mike, what did you use to slice up the phone book so cleanly?   Chin

I just fed it through my vertical bandsaw.  If memory serves I think I was able to make about four sections so I should be covered for a long time.


(11-23-2015, 10:12 PM)Vinny Wrote: Dunno what Mike used, but clamping a book between two pieces of wood will allow you to cleanly cut it with a band saw.

I thought about that but it actually came out quite clean without needing any kind of "backer".

(11-24-2015, 12:57 AM)Mayhem Wrote: I just grab them and rip them in half Big Grin

I tried that but they didn't come out even enough and my OCD kicked in. Big Grin

Mike.

Reply
Thanks given by:
Are pages form the machine shop section more accurate than others?
Hunting American dentists since 2015.
Reply
Thanks given by:
(11-24-2015, 12:57 AM)Mayhem Wrote: I just grab them and rip them in half Big Grin

Given there are no pics, it didn't happen. Popcorn
Reply
Thanks given by:
Gift wrapping tissue: .001"

Phone book paper with a drop of oil will keep your fingers out of there. Feed in until the paper moves, you'll be about .001" away. Or less... whoops. Smile
Reply
Thanks given by:




Users browsing this thread: 52 Guest(s)