Todays Project - What did you do today?
he just move the one a little on the paper to fool us into thinking theres two of them. Yikes Yikes Yikes
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
Not a good day today.
The magic smoke escaped from the motor condenser on the mini lathe, so I had to get a new one from the wizard
The one he gave me was smaller in size but he said it had the same amount of smoke, anyway it worked OK
   

Brian. Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
How bad can it be Brian? I had to work all day 17428 

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:




Luckily I did not have to work today. The day was spent driving the kids here and there and picking up my new to me power hack saw.
Steve S
Check out MyShopNotes on youtube.
Reply
Thanks given by:
Ooh! I have hacksaw envy. Every time my Chinese bandsaw acts up, I think about getting one.
Reply
Thanks given by:
(08-07-2015, 11:47 PM)Roadracer_Al Wrote: Ooh!  I have hacksaw envy.  Every time my Chinese bandsaw acts up, I think about getting one.

They are slower than a bandsaw but once setup you really don't need to so anything else to them.
Steve S
Check out MyShopNotes on youtube.
Reply
Thanks given by:
My only issue with power hacksaws is that they so quickly wear out the teeth on one end of the blade and you end up throwing out a blade with new teeth on the other end you can't use. At least a bandsaw uses every tooth! Mine is a "set it and forget it" with the hydraulic piston controlling the feed rate. Not so in vertical position of course, but 90% of its use is horizontal, just like the power hacksaw.
Reply
Thanks given by:
You can usually move the vice location to use fresh parts of the blade to avoid that issue
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
(08-10-2015, 02:19 AM)awemawson Wrote: You can usually move the vice location to use fresh parts of the blade to avoid that issue

This hacksaw does have a means to position the vice at different points.
Steve S
Check out MyShopNotes on youtube.
Reply
Thanks given by:
Most power hacksaws would (or should) have that feature with the vise. In your video the solid jaw appears to have been pinned and bolted. Is that so?

It may have alternate pin holes too, I just don't know. What I do know is that most users never bother to move it until the blade is worn so bad on one end that it won't cut, and they forgot it was their last blade.

Big Grin
Reply
Thanks given by:




Users browsing this thread: 26 Guest(s)