Wire clamp tool...

[claudef]

Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF

[Highpower]

(08-16-2012, 07:09 AM)claudef Wrote: Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF

It sure looks like it works well. Tight and tidy clamps.

[DaveH]

ClaudeF,

Nicely made tool
Looks like it's works very well too

DaveH