Posts: 157
Threads: 18
Joined: Apr 2012
Location: Damascus, Or
My x-axis movement is good in the middle of the travel but tightens up at each end in the last 3 to 4 inches. I bought it new in Feb and most of the work I have done has been in the middle of the table until recently so I hadn't noticed the difference. Does this mean the gibs need to be adjusted? Could it just be a breakin issue?
The y-axis is smooth for the full travel but that's only 8 in compared to 22 in.
Dan
Collecting tools for 30 years.
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
I don't think adjusting the gib will do it. If you tighten the gib in the middle you won't move the table at the ends. If you loosen the gib so as to be smooth at the ends it'll be real sloppy in the middle.
I'd guess it's time to scrape the ends.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Posts: 8,889
Threads: 320
Joined: Feb 2012
Location: Arizona/Minnesota
My guess is that the X nut is probably sitting too low and bows the leadscrew enough to feel OK when the travel is in the middle but tightens up as you reach the ends.
Ed
Posts: 157
Threads: 18
Joined: Apr 2012
Location: Damascus, Or
Ed,
Can I shim this up without removing the table?
Dan
Collecting tools for 30 years.
Posts: 8,889
Threads: 320
Joined: Feb 2012
Location: Arizona/Minnesota
Dan,
Unfortunately not. You'll need to remove the table, which is not that hard to do. Just be sure to have another strong body to help because the table is fairly heavy for one person to handle. The hard part is figuring out how much to shim up the nut to get it so it's inline with the table ends. You might be able to get fairly close by sighting from one end of the table through the nut to the other end after removing the leadscrew.
Ed
