P&W 1830 Radial in 1/6 scale.
Almost there. Only milling to go.

"Billy G" Big Grin


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
The TWINS have arrived. Rotfl That was some ordeal.

"Billy G" Thumbsup


Attached Files Thumbnail(s)
   
Reply
Thanks given by: Arbalest
That's a very nice pair Bill. Big Grin
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Thank you, just over 23 hours work Tom. I'm beat.

"Billy G" Sleep
Reply
Thanks given by:
Nice work. I really like radials, will be watching with interest.
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
Bill, this is getting exciting.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
Asbalest thank you very much, Hawkeye, nice to see you. OK people, if you are not into repetative operations this is a bad project for you. Slave rods are next. Again these will be for the 18, not the 14 cylinder. That translates to 16 of the same part. See you soon.

"Billy G"
Reply
Thanks given by:
Billy,
Damn nice job Smiley-signs107 Worthy very smart.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Still needs to be bolted to the table but this is the set-up for cutting the 16 tooh gear which is an integral part of the crankshaft forward part.

"Billy G"
Reply
Thanks given by:
Picture posting problem at this end. It is more complicated that windows 7.

"Billy G"
Reply
Thanks given by:




Users browsing this thread: 12 Guest(s)