Scissor knurler
#1
I made this scissor knurler a few years ago, as you can see by the rust it doesn't get a lot of use.  The wheels I bought on ebay, the remainder I made myself.  It works quite well.  I made up a couple of stainless cable adjusters the other day, so dragged out the knurler.  The cable adjuster was turned down from 8mm 304.   turned down to 6.37mm and then threaded 1/4" UNF for 40mm, then drilled through with a 3mm hole, the top section drilled out to 5.5mm for the cable then knurled.


Attached Files Thumbnail(s)
               
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)