11-20-2021, 09:09 AM
Hi everyone.
I need to replace the bearings in my TheMac J40 #445 spindle, it sounded like it had marbles in it, when I used it the other day. Yes I oiled it with Mobil light spindle oil before turning it buy hand before powering it up. It is an older model J40 I bought about 15 yrs ago. Any help like bearing numbers, suggestions on reassembly, what to use to clean the gunk from inside, can I reuse the the oil pads inside the spindle. There are no numbers on the the bearings. So I need to find replacements.the RPMs on the side of the spindle is stamp is 9300 RPM. Any help will be greatly appreciated.
CH
I need to replace the bearings in my TheMac J40 #445 spindle, it sounded like it had marbles in it, when I used it the other day. Yes I oiled it with Mobil light spindle oil before turning it buy hand before powering it up. It is an older model J40 I bought about 15 yrs ago. Any help like bearing numbers, suggestions on reassembly, what to use to clean the gunk from inside, can I reuse the the oil pads inside the spindle. There are no numbers on the the bearings. So I need to find replacements.the RPMs on the side of the spindle is stamp is 9300 RPM. Any help will be greatly appreciated.
CH
