Posts: 2,617
Threads: 100
Joined: Dec 2014
Location: Michigan
(06-27-2020, 10:10 PM)arvidj Wrote: (06-27-2020, 05:33 PM)EdK Wrote: Any suggestions for a source of reasonably priced filament of good quality? 
Ed
I've found Microcenter's Inland brand PLA to be a very good value. They have lots stock and colors on hand and at $19 a 1kg spool it's hard to beat. There may be better quality filaments out there but for what I print it does job.
I'm in the process of building an enclosure so I can give their ABS a try.
I went thru all that: hood over the printer, vent fan vented outside, ... I forgot to turn it on and found fumes were undetectable. I am in a garage/shop with 10' ceilings but I still should've smelled something.
Posts: 735
Threads: 34
Joined: Feb 2012
Location: Minneapolis, MN
The following 3 users Like arvidj's post:
Highpower (06-28-2020), EdK (06-28-2020), Vinny (06-30-2020)
(06-28-2020, 01:34 AM)Vinny Wrote: I went thru all that: hood over the printer, vent fan vented outside, ... I forgot to turn it on and found fumes were undetectable. I am in a garage/shop with 10' ceilings but I still should've smelled something.
Originally I was justifying it for draft and heat control for ABS rather than the smell.
In hind sight the major benefit of the enclosure will be to give the impression the printer and all the paraphernalia has a permanent home (5 years in the making) so Bev will get off my case about it being scattered all over the room.
