Mini Hog
#1
Here is an engine I designed up and just finished.


Reply
Thanks given by:
#2
Very nice Doc - I love it :)

Not too happy about where you plan to place your auxiliary spark gap though. It will generate heat and if enclosed bad things might happen before you realise it and start a fire. I'd place it outside and visible.
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
#3
Very nice. It has the low rpm lope of the real thing. :)

Is that a Model T spark coil?

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#4
(03-20-2019, 11:00 AM)awemawson Wrote: Very nice Doc - I love it :)

Not too happy about where you plan to place your auxiliary spark gap though. It will generate heat and if enclosed bad things might happen before you realise it and start a fire. I'd place it outside and visible.

Since the video I have come to pretty much the same conclusion and ame going to put it out where it is visible so I can see whats going on. Thanks for the heads up!
Reply
Thanks given by:
#5
(03-20-2019, 12:20 PM)TomG Wrote: Very nice. It has the low rpm lope of the real thing. :)

Is that a Model T spark coil?

Tom
Thanks Tom!
No thats a coil I designed and works off  of 2 hall effect sensors. I do plan on rebuilding (or trying to) a model T coil. Plus wind some more coils and try and get the voltage it will throw a good spark down to 2 to 3 volts.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)