Project Bridgeport Rebuild
#71
Got any pictures of the quick adjust set up lads? Sounds like something I should look?

Cheers
John
Reply
Thanks given by:
#72
Here's one style. There are others.

http://www.mscdirect.com/product/details/09506114
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:
#73
Mike posted the same style I got, KBC tools has them in the latest flier.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#74
Is this something I should consider getting? 

I assume you just release and slide to where you want it, saving time by not having to spin the nut up and down.
Reply
Thanks given by:
#75
I think it will be worth it, haven't had it too long. The fine thread nuts probably haven't been used more than 3 or 4 times in all the years I've had the mill, it wasn't worth the effort. If I needed equal chamfers say, it was easier to use the knee.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#76
Yes that's identical to the one I've had for ages and wouldn't be without. Very well worth fitting in my view.
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
#77
Definitely worth it. I haven't installed mine yet but spinning the nuts gets old real quick.

Ed
Reply
Thanks given by:
#78
Thought I'd post a very quick update as there is not much happening on the forum.

So during the dissemble I spent several minutes trying to find the quill skirt that I'm supposed to remove.  I know what I looks like from the pictures but I just can't seem to find it, it's now obvious that it doesn't have one so I'm feeling a little on the stupid side.

Also  I know I'm getting ahead of myself here but I'm starting to think about the reassembly, in particular the motor.

The current motor is a 660 volt 3 phase unit so I don't think it will plug into my wall outlet Big Grin 

Do you think this is worth trying to sell on? And if so any suggestions where to advertise it outside of the obvious, eBay etc.

Cheers
John (nice but dim)
Reply
Thanks given by:
#79
John

Is your drift you want to move (re-sell get rid of) this full size machine?
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
#80
(01-14-2017, 12:37 PM)ieezitin Wrote: John

Is your drift you want to move (re-sell get rid of) this full size machine?

No, I just want to sell the motor as it's the wrong voltage.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)