Low profile clamp for 4” Vertex RT

Thread Modes

Low profile clamp for 4” Vertex RT

chucketn Offline

Junior

Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN

11-29-2016, 01:45 PM (This post was last modified: 11-29-2016, 02:20 PM by chucketn.)

I want to make a couple of low profile clamps for my RT, as shown in the attached photo, to clamp my RT on my X2 mill, in the horizontal postion. I have 6061 aluminum, or I could make a pattern and cast it out of wheelium. I plan to put 3 bolt holes in it as shown in the picture.
Will either material be strong enough?
Any other suggestions on dimentions or features?
I have tried contacting the web site where I got the photo, but no response.

Chuck

Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.

Like Post

Vinny

Another Whipping Boy

Posts: 2,618
Threads: 100
Joined: Dec 2014
Location: Michigan

11-29-2016, 02:10 PM

attached photo?

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Like Post