11-27-2015, 09:49 PM
Setting Up My PM935 Mill
|
11-28-2015, 03:38 PM
11-28-2015, 03:58 PM
11-28-2015, 04:28 PM
11-28-2015, 06:52 PM
Progress.
There is some!
11-28-2015, 07:19 PM
ANY THING HAPPNEN?
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
11-28-2015, 07:33 PM
11-28-2015, 07:33 PM
11-28-2015, 08:30 PM
Slow progress is still progress Ed. This is something that you don't want to rush, as the consequences are serious. Whilst this is probably not going to be of much use here, here is a picture of the stand that I made to remove the head from the knuckle on my Kondia:
http://www.metalworkingfun.com/thread-57...l#pid42783 Perhaps if you have a large enough piece of round stock held in a collet, you could do the same. It really does make getting the head off and on so much easier, as the mill holds the weigh and you use the various axis to line everything up and keep it aligned and level.
Hunting American dentists since 2015.
Thanks given by: EdK
12-05-2015, 01:46 PM
(11-27-2015, 07:49 PM)f350ca Wrote: Set up the way you have it in the last photo Ed, with the head sitting on the table. You should be able to hook up the hoist to stabilize it and retract the arm on the column till the studs are clear. Worked like a champ Greg. I have head freedom. Next, lunch then head extraction. Ed |
« Next Oldest | Next Newest »
|
Users browsing this thread: 26 Guest(s)