Heat treat furnace
#71
If it were me, I'd go with two, but there's no engineering schooling on mine either.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
#72
take it off both sides so the key stays centered. that's from putting 100 HP drives together with a stepped key in them.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
#73
(12-23-2015, 05:44 PM)dallen Wrote: .... that's from putting 100 HP drives together with a stepped key in them.

Yikes

Sounds good enough to me! Thanks guys. Smiley-eatdrink004
Willie
Reply
Thanks given by:
#74
Late reply Willie but any stepped keys I've seen are cut on both sides.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by: Highpower




Users browsing this thread: 1 Guest(s)