11-17-2015, 09:33 AM
(11-14-2015, 10:52 PM)wawoodman Wrote: I'm going to jump in here, because this in on my project list, as well. Everything I see seems to require that flat plate base, and removing the compound. Is there a way to utilize the T-slot in the compound? That is, just slide out the QCTP, and slide in the ball turner? Or is that a bad idea?
I am going to subscribe because a ball/radius turner is also on my "to do" list. I was thinking of doing the same thing, just using the "T" nut in the cross-slide as the attachment point, but I haven't dug deep enough in to see if that will reach the lathe centerline.
If anyone has any pictures of their ball/radius turning tool attached to the "T" nut I would be greatful to see it.
Mike.