Billy G's Die Filer
A place in Plainville is going to do just that Ken. It goes in to the shop on Monday. #$85.00, back to me in 3 days.

"Billy G"
Reply
Thanks given by:
Started the leg mounts, but I have to leave now. Thank you all for the kind words and suggestions.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
Mounts are done. I don't think we need to document them Ed. They are pretty straight forward. I will if someone needs them.

"Billy G"


Attached Files Thumbnail(s)
       
Reply
Thanks given by:
(04-10-2015, 01:02 PM)Bill Gruby Wrote: Mounts are done. I don't think we need to document them Ed. They are pretty straight forward. I will if someone needs them.

"Billy G"

That was my thought also. Plus, there are numerous ways to mount it so I think it makes sense to leave that up to the builder.

Ed
Reply
Thanks given by:
This is my rendition of the knobs for the Table Tilt. They are made from Nylon. Only two things left, the Chuck and the Guard to enclose the front.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
We will get back to this very soon. Sophie is scheduled to come home next Thursday. Thank you all for your thoughts.

"Billy G"
Reply
Thanks given by:
that's great Billy!!

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
were all the changes to the prints posted as a new pdf for download?

Just asking as the last attached file I see still shows the crank pin offset as .750 instead of 1" as per Billy G
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
(04-22-2015, 07:43 AM)dallen Wrote: were all the changes to the prints posted as a new pdf for download?

Just asking as the last attached file I see still shows the crank pin offset as .750 instead of 1" as per Billy G

See this: http://www.metalworkingfun.com/showthrea...9#pid42899

Ed
Reply
Thanks given by:
(04-22-2015, 11:35 AM)EdK Wrote:
(04-22-2015, 07:43 AM)dallen Wrote: were all the changes to the prints posted as a new pdf for download?

Just asking as the last attached file I see still shows the crank pin offset as .750 instead of 1" as per Billy G

See this: http://www.metalworkingfun.com/showthrea...9#pid42899

Ed

Page 8 of the drawings still shows the offset of the pin as .750" instead of the 1" as noted in message 156

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)