MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Lathe slotting tool

Thread Modes
Lathe slotting tool
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#11
09-21-2014, 08:07 PM
(09-21-2014, 12:39 PM)RobWilson. Wrote: Hi Chuck , sorry but I don't do PMs or Emails any more , just open forum .


Regards Rob
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:
RobWilson
Unregistered
 
#12
09-22-2014, 05:50 AM
Was there a reply there Chuck Chin

Rob
Reply
Thanks given by:
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#13
09-22-2014, 07:35 AM
(09-22-2014, 05:50 AM)RobWilson. Wrote: Was there a reply there Chuck Chin

Rob

No, not necessary.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)