03-21-2014, 03:36 PM
A friend came by yesterday and gave me a new/old heat unit for the shop. The other one burned out a few months ago, Also gave me the one I had.
He is one of the local scrap guys around here and I"ve known him about 20 years. When he first started I gave him all my scrap and then it was always a lot.
As you can see in the first picture he also gave me 10 end mills and one small reamer.
The second picture is some lead 1" thick 7"wide and 5" deep close to 40# of good lead. I'll have to check the hardness on it, Its not soft enough to be pure but it will make a lot of bullets.
Paul
He is one of the local scrap guys around here and I"ve known him about 20 years. When he first started I gave him all my scrap and then it was always a lot.
As you can see in the first picture he also gave me 10 end mills and one small reamer.
The second picture is some lead 1" thick 7"wide and 5" deep close to 40# of good lead. I'll have to check the hardness on it, Its not soft enough to be pure but it will make a lot of bullets.
Paul
Old Iron`, proud to be a member of MetalworkingFun Forum since Feb 2014.