02-26-2012, 01:38 AM
This is going to be a very slowly updated thread but I was cleaning some pics of off my phone and found these two.
So I thought I would post them before they get deleted. That is the beer keg I am going to make my furnace out of being held in the 14" chuck on my lathe. I had originally planned to use the lathe to part the keg but was so disappointed to find that my cross slide is just a fraction to high. There is literally a 1/2" between the vision and reality :(
I ended up using the plasma cutter Well this is my starting point and I am looking toward Rob and John and their work to turn this keg into a furnace.
So I thought I would post them before they get deleted. That is the beer keg I am going to make my furnace out of being held in the 14" chuck on my lathe. I had originally planned to use the lathe to part the keg but was so disappointed to find that my cross slide is just a fraction to high. There is literally a 1/2" between the vision and reality :(
I ended up using the plasma cutter Well this is my starting point and I am looking toward Rob and John and their work to turn this keg into a furnace.
Hunting American dentists since 2015.