Posts: 184
Threads: 21
Joined: Feb 2013
Location: north yorkshire n.e.england
The following 3 users Like the artfull-codger's post:
EdK (09-17-2013), Mayhem (09-17-2013), oldgoaly (09-18-2013)
A couple of engines I built for the grandchildren of my neighbour 5 yr olds but mad on steam engines, lovelly lads allways go on ''albert'' when out round the village.
the artfull-codger, proud to be a member of MetalworkingFun Forum since Feb 2013.
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
Nicely done! Would love to have you as my neighbor. Your own design?
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Posts: 184
Threads: 21
Joined: Feb 2013
Location: north yorkshire n.e.england
09-17-2013, 04:36 PM
(This post was last modified: 09-17-2013, 04:54 PM by the artfull-codger.)
(09-17-2013, 03:50 PM)chucketn Wrote: Nicely done! Would love to have you as my neighbor. Your own design?
Chuck
Thanks Chuck, no I got the design from a book in our dept at work entitled ''model engineering for schools'' & made my grandson one then I taught lads at school to make them at lunchtimes,even got an article published in ''model engineer'' magazine in april 2009, if you want to see one running ,go on youtube & type in kylegale1 & one of the lads put his engine on running.
Graham.
the artfull-codger, proud to be a member of MetalworkingFun Forum since Feb 2013.