HI well this is my atempt at making a small runing center ther is a tip for you all rather than mack up morce tapers I cheet I by broken drills and reemers with morce tapers on them cut the drill or the reemer off and you have a morce taper to play with right on with the job turnd dawn the end of the MT2 to fit a stanles steel end see pic then silver solderd the two together drilld out the center 8mm then to the sise of the berings being used sos can not remember the OD of the berings but the internal diamiter was 8 mm then got sum silver steel and turnd the end dawn to 8mm with the end just undre that then made up a ring to go over the end to keep the muck out drilld and taped a hole so far dawn on the stanles steel holder of the berings this is for loking the revolving center when cuting the point and then being used to keep it lubreketed sos if its all a bit vage as this was dun sum time a go but i think you will get the jist of things with the pics haw can i post more than 4 pics at a time ???
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
