Running a shaper - the compound
#11
    And since last winter when I came up with this, since then I have
powered its rotation with about .005 in time with the ram stroke.
That is how I can do round tapers more like as the world turns, (work)
the ram is cutting the taper. May be crazy, but with a lathe, one must
stay with it UNLESS you have a taper att. which I do not. So Its kind
of like a power hack saw - turn on switch walk a way just comming
back time to time to add a little down feed.
big job, proud to be a member of MetalworkingFun since Jun 2012.
Reply
Thanks given by:


Messages In This Thread
RE: Running a shaper - the compound - by Mayhem - 09-04-2012, 08:35 AM
RE: Running a shaper - the compound - by dallen - 09-04-2012, 08:48 AM
RE: Running a shaper - the compound - by f350ca - 09-04-2012, 09:27 AM
RE: Running a shaper - the compound - by big job - 09-06-2012, 05:24 AM
RE: Running a shaper - the compound - by stevec - 09-06-2012, 06:38 AM
RE: Running a shaper - the compound - by big job - 09-07-2012, 05:03 AM
RE: Running a shaper - the compound - by stevec - 09-07-2012, 06:52 AM
RE: Running a shaper - the compound - by big job - 09-07-2012, 05:17 AM
RE: Running a shaper - the compound - by EdK - 09-07-2012, 05:33 AM
RE: Running a shaper - the compound - by big job - 09-07-2012, 06:29 AM
RE: Running a shaper - the compound - by stevec - 09-07-2012, 07:11 AM
RE: Running a shaper - the compound - by big job - 09-08-2012, 05:05 AM
RE: Running a shaper - the compound - by f350ca - 09-08-2012, 10:52 AM
RE: Running a shaper - the compound - by big job - 09-09-2012, 07:49 AM
RE: Running a shaper - the compound - by dallen - 09-09-2012, 08:50 AM
RE: Running a shaper - the compound - by f350ca - 09-09-2012, 10:44 AM
RE: Running a shaper - the compound - by f350ca - 09-09-2012, 09:45 PM
RE: Running a shaper - the compound - by f350ca - 09-11-2012, 10:37 PM
RE: Running a shaper - the compound - by EdK - 09-12-2012, 05:32 AM
RE: Running a shaper - the compound - by Mayhem - 09-12-2012, 05:54 AM
RE: Running a shaper - the compound - by big job - 09-14-2012, 05:57 AM
RE: Running a shaper - the compound - by stevec - 09-20-2012, 05:01 PM



Users browsing this thread: 1 Guest(s)