ER25 vs ER32 ?

Hello There, Guest! Register

Thread Modes

ER25 vs ER32 ?

Bill Gruby
Unregistered

#13

07-01-2012, 01:11 PM

That's not really a drew bar needed on that ER 40 unit. All you need is something to back up the hold of the taper. A piece of all-thread, couple of nuts and washers will do. The collet is tightened with the nut on the front. I jist use the thru spindle stop I made.

"Billy G" Big Grin

Big Grin

Attached Files Thumbnail(s)

Reply

« Next Oldest | Next Newest »

Messages In This Thread

ER25 vs ER32 ? - by DanH - 06-30-2012, 02:54 PM

RE: ER25 vs ER32 ? - by DaveH - 06-30-2012, 03:11 PM

RE: ER25 vs ER32 ? - by Bill Gruby - 06-30-2012, 04:10 PM

RE: ER25 vs ER32 ? - by Mayhem - 06-30-2012, 11:21 PM

RE: ER25 vs ER32 ? - by henryarnold - 07-01-2012, 01:39 AM

RE: ER25 vs ER32 ? - by Mayhem - 07-01-2012, 03:56 AM

RE: ER25 vs ER32 ? - by DanH - 07-01-2012, 09:47 AM

RE: ER25 vs ER32 ? - by Bill Gruby - 07-01-2012, 09:50 AM

RE: ER25 vs ER32 ? - by doubleboost - 07-01-2012, 10:43 AM

RE: ER25 vs ER32 ? - by henryarnold - 07-01-2012, 12:39 PM

RE: ER25 vs ER32 ? - by DanH - 07-01-2012, 03:02 PM

RE: ER25 vs ER32 ? - by henryarnold - 07-02-2012, 10:21 AM

RE: ER25 vs ER32 ? - by EdK - 07-01-2012, 12:50 PM

RE: ER25 vs ER32 ? - by henryarnold - 07-01-2012, 01:01 PM

RE: ER25 vs ER32 ? - by EdK - 07-01-2012, 01:23 PM

RE: ER25 vs ER32 ? - by stevec - 07-02-2012, 03:23 PM

RE: ER25 vs ER32 ? - by EdK - 07-02-2012, 04:37 PM

RE: ER25 vs ER32 ? - by Bill Gruby - 07-01-2012, 01:11 PM

RE: ER25 vs ER32 ? - by stevec - 07-02-2012, 06:06 PM

RE: ER25 vs ER32 ? - by EdK - 07-02-2012, 06:24 PM

Users browsing this thread: 1 Guest(s)