Bonehead Move
#5
The first one was funny. Hope you didn't ding up the spindle bore, Ed.

Highpower, I feel your pain. I know endmills are supposed to be consumables, but for me that's not usually an issue unless I mess them up.
Full of ideas, but slow to produce parts
Reply
Thanks given by: EdK


Messages In This Thread
Bonehead Move - by EdK - 01-21-2024, 08:37 PM
RE: Bonehead Move - by EdK - 01-21-2024, 08:47 PM
RE: Bonehead Move - by rubes - 01-21-2024, 10:12 PM
RE: Bonehead Move - by Highpower - 01-22-2024, 02:17 AM
RE: Bonehead Move - by rleete - 01-22-2024, 07:54 AM
RE: Bonehead Move - by Highpower - 01-22-2024, 01:20 PM
RE: Bonehead Move - by EdK - 01-22-2024, 11:29 AM
RE: Bonehead Move - by EdK - 01-22-2024, 02:54 PM
RE: Bonehead Move - by Highpower - 01-22-2024, 05:32 PM
RE: Bonehead Move - by rleete - 01-22-2024, 06:46 PM



Users browsing this thread: 1 Guest(s)