MetalworkingFun Forum › Machinery › Milling Machines v
X Power Feed

Thread Modes
X Power Feed
EdK Offline
Whipping Boy
*******
Posts: 8,746
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
The following 4 users Like EdK's post:
Highpower (05-12-2023), arvidj (05-12-2023), Vinny (05-13-2023), JScott (05-13-2023)
#8
05-12-2023, 06:10 PM
I got the problem fixed that was causing the power supply to shut down when turning the speed down at a fast rate. I read the datasheet for the power supply and it said that if it's an inductive load it's best to put a diode in series with the load. I did that and it fixed the problem. It was clearly a problem with back EMF. It took me longer to find the 60V, 35A Schottky diode I knew I had somewhere than it did to incorporate the fix and test it.
Now it's on to figuring out the mechanical side of this project.  Chin

Ed
Reply
Thanks given by:


Messages In This Thread
X Power Feed - by EdK - 05-08-2023, 03:28 PM
RE: X Power Feed - by EdK - 05-13-2023, 02:16 PM
RE: X Power Feed - by EdK - 05-20-2023, 10:55 AM
RE: X Power Feed - by EdK - 05-21-2023, 11:36 PM
RE: X Power Feed - by EdK - 05-22-2023, 06:10 PM
RE: X Power Feed - by EdK - 05-26-2023, 05:50 PM
RE: X Power Feed - by EdK - 05-30-2023, 11:14 PM
RE: X Power Feed - by Highpower - 05-31-2023, 03:03 AM
RE: X Power Feed - by EdK - 06-03-2023, 12:49 AM
RE: X Power Feed - by EdK - 12-18-2023, 02:58 PM
RE: X Power Feed - by Highpower - 12-18-2023, 05:03 PM
RE: X Power Feed - by EdK - 12-18-2023, 07:44 PM
RE: X Power Feed - by rleete - 03-22-2024, 06:18 AM
RE: X Power Feed - by EdK - 03-22-2024, 11:33 AM
RE: X Power Feed - by rleete - 03-23-2024, 08:48 AM
RE: Todays Project - What did you do today? - by EdK - 05-12-2023, 06:10 PM
X Power Feed - by EdK - 05-13-2023, 02:07 PM



Users browsing this thread: 1 Guest(s)