10-28-2022, 09:41 AM
That unit (similar in form to many 3D printers) might be fine as a printer, and possibly even a laser. But the laser won't cut much more than very thin (1/16") softwoods, and probably take multiple passes, which blackens the edges, and makes for sloppy looking parts. It certainly won't have the rigidity necessary for carving much of anything.
And I'd be quite concerned about the noise it makes. Creality (maker of the Ender series), has gone through several iterations of the motherboards to eliminate stepper motor noise. I'd very much doubt this one has anything but the very cheapest board, meaning it will drive you nuts unless it is in the garage or basement. The router head is bound to whine like a teenager with no spending money and be just about as powerless.
If it looks too good to be true, it probably is. I agree with Vinny. Don't buy.
And I'd be quite concerned about the noise it makes. Creality (maker of the Ender series), has gone through several iterations of the motherboards to eliminate stepper motor noise. I'd very much doubt this one has anything but the very cheapest board, meaning it will drive you nuts unless it is in the garage or basement. The router head is bound to whine like a teenager with no spending money and be just about as powerless.
If it looks too good to be true, it probably is. I agree with Vinny. Don't buy.
Full of ideas, but slow to produce parts