Teflon tips and tricks - got any?
#6
(05-02-2021, 10:15 PM)Hawkeye Wrote: I've cut Teflon with a table saw. Any sharp blade cuts well. Just hold it firmly and control the speed of the cut. Don't want to risk grabbing it and throwing it around the room.

Ditto on the table saw.  2nd choice would be a vertical band saw. When machining plastics in general make sure you keep the temperature under control otherwise it will warp. Use lots of air to keep it cool along with a minimal amount of coolant. Flipping it 180 degrees in the vice will also help and make sure you are not aggressive with the DOC and with the amount of pressure applied by the vice.
Reply
Thanks given by:


Messages In This Thread
Teflon tips and tricks - got any? - by Highpower - 05-02-2021, 03:20 PM
RE: Teflon tips and tricks - got any? - by f350ca - 05-02-2021, 07:11 PM
RE: Teflon tips and tricks - got any? - by Dr Stan - 05-03-2021, 09:25 AM
RE: Teflon tips and tricks - got any? - by rleete - 01-21-2022, 08:34 AM



Users browsing this thread: 2 Guest(s)